|
On the bottom of your x-box, under the rubber pads theres 4 screws(which need a special hex screw driver)and also under 2 stickers theres another 2 screws, after you get those off the top just comes off. Finally came the front face place, this took abit longer. Theres another little clip on there that holds that on, once you get that off (the circuit board) just replace on the new face plate and reassemble in the opposite order of removal. I recently ordered and recieved this product, it was relativly easy to install, it did take about 15 minutes to a half hour, I took my time trying not to break anything important. Once you get the face plate loose, DONT PULL IT OFF FAST, there's a little circiut board and wiring on there for the power/eject buttons. Overall, this is a really good product, it looks really cool when you turn the power on and the L.E.D.S. light up the front of the xbox.
On the bottom of the face plate there's 3 tabs that hold it inplace, also to remove on either side there are plastic clips that look like the letter V, take a flat screw driver again and compress the V and pop it loose and hold it in place (loose) and move along the bottom and pop out the other clips, and just repeat the on the other side for the V clip. Next was the cd-drive cover, on that I used a flat screw driver and lightly pried on the bottom (theres 2 tabs that it hold on) and that popped off and just replaced with the new one. IMPORTANT. The only issues were that it didn't come with instructions, and it came with an extra piece that I couldnt figure out were it went.
|
